We are recognized as one of the renowned Submersible Pumps Manufacturers, Suppliers and Exporters. Our Submersible Pumps are widely appreciated and demanded due to its compact and ergonomic design. Our Submersible Pumps are easy to install and do not require foundation or pump house. The installation costs incurred are very low and these Submersible Pumps give higher output at lower power consumption. Our Submersible Pumps are used in Tube-well Irrigation, Open-well Irrigation, Drip Irrigation and Sprinkler Irrigation and other industrial applications. These Submersible Pumps are manufactured as per IS: 8034 / 2002. Our Submersible Pumps are noiseless and cost-effective.


Our Select Range Of Submersible Pumps Includes


  • Agriculture Submersible Pumps
  • Industrial Submersible Pumps


The Motor


  • Motors are squirrel cage type totally enclosed, wet type induction motor suitable for Single Phase, 230V / 3 Phase, 415 volts, 50 c/s a.c. supply, filled with pure drnking water
  • Dual seals and sand guard are provided for protection and to avoid contamination of outside borewell water
  • Stator made of Stainless Steel pipe
  • Stator & Rotors are impregnated with varnish under vacuum and baked-under controlled temperature to avoid rusting in water
  • Stainless steel sleeves are shrink fitted at bearing locations on rotor shaft and ground to closer tolerance for smooth running
  • Winding wire is made from water resistance P.V.C. Coated / Poly coated copper wire
  • Rotor assembly is dynamically balanced for vibration free operation
  • Rotor bars are of electrolytic grade copper
  • All the bush bearings are water lubricated
  • Thrust bearing assembly is fitted with tilted pads resting on S.S. Balls and supported by locating pin to take the higher axial load
  • The revolving thrust plate is made from S.S. & fitted with teflon securely fixed to the S.S. Plate
  • Rubber diaphragm is provided at the base of the motor to equalise pressure caused by variation in temperature during operation
  • Lead cables are protected with rubber gromets


The Pump


  • It is vertical multistage centrifugal pump with either radial flow or mixed flow type Stainless Steel impeller
  • Impellers are dynamically balanced. All the stationary parts are closed grained graded CI with smooth profiles without any defects
  • All the Bearing Bush are self water lubricated type
  • The Pumpshaft Sleeves & Coupling are manufactured from Stainless Steel
  • Impeller & sleeves are securely fixed on S.S. Shaft with S.S. Key
  • The bowls are locked by bolting to avail high Concentric accuracy and better reliability
  • A stream lined non return valve provided to prevent reverse rotation of pump assembly while switched off

S.S. Suction strainer is provided to avoid entry of suspended material in water

  • To protect cable from being wearing out during installation, cable guards are provided all along the pump body